Rainbow-electronics MAX4029 Manuel d'utilisateur

General DescriptionThe MAX4028/MAX4029 are 5V, triple/quad, 2:1 voltage-feedback multiplexer-amplifiers with input clamps and afixed gain of +2V/V (6d

MAX4028/MAX4029Although the MAX4028/MAX4029 are optimized for ACperformance and are not designed to drive highlycapacitive loads, they are capable of

The bypass capacitors should include a 0.1µF, ceramicsurface-mount capacitor between VCCand the groundplane, located as close to the package as possib

MAX4028/MAX4029Triple/Quad, 2:1 VideoMultiplexer-Amplifiers with Input Clamps12 ______________________________________________________________________

MAX4028/MAX4029Triple/Quad, 2:1 VideoMultiplexer-Amplifiers with Input ClampsMaxim cannot assume responsibility for use of any circuitry other than ci

MAX4028/MAX4029Triple/Quad, 2:1 VideoMultiplexer-Amplifiers with Input Clamps2 _______________________________________________________________________

MAX4028/MAX4029Triple/Quad, 2:1 VideoMultiplexer-Amplifiers with Input Clamps_________________________________________________________________________

MAX4028/MAX4029Triple/Quad, 2:1 VideoMultiplexer-Amplifiers with Input Clamps4 _______________________________________________________________________

MAX4028/MAX4029Triple/Quad, 2:1 VideoMultiplexer-Amplifiers with Input Clamps_________________________________________________________________________

MAX4028/MAX4029Triple/Quad, 2:1 VideoMultiplexer-Amplifiers with Input Clamps6 _______________________________________________________________________

Detailed DescriptionThe MAX4028/MAX4029 are 5V, triple/quad, 2:1 voltage-feedback multiplexer-amplifiers with input clamps and afixed gain of +2V/V (6

MAX4028/MAX4029Therefore, a 6kΩ resistor will produce a 1.13V key-clamp voltage as shown in Figure 2. The clamp voltage(VCLAMP) is measured at the out

The MAX4028/MAX4029 have a fixed gain of +2V/V thatis internally set with two 1kΩ thin-film resistors. Theimpedance of the internal feedback resistors