Rainbow-electronics ATmega103L Manuel d'utilisateur télécharger pdf (Page 110)

ATmega603/103

110

Typical characteristics

The following charts show typical behavior. These data are characterized, but not tested. All current consumption measure-

ments are performed with all I/O pins configured as inputs and with internal pull-ups enabled. All pins on Port F pulled high

externally. A sine wave generator with rail to rail output is used as clock source.

The power consumption in power-down mode is independent of clock selection.

The current consumption is a function of several factors such as: operating voltage, operating frequency, loading of I/O

pins, switching rate of I/O pins, code executed and ambient temperature. The dominating factors are operating voltage and

frequency.

The current drawn from capacitive loaded pins may be estimated (for one pin) as C

*f where C

= load capacitance,

= operating voltage and f = average switching frequency of I/O pin.

The parts are characterized at frequencies higher than test limits. Parts are not guaranteed to function properly at frequen-

cies higher than the ordering code indicates.

The difference between current consumption in Power Down mode with Watchdog timer enabled and Power Down mode

with Watchdog timer disabled represents the differential current drawn by the watchdog timer.

Figure 80. Active Supply Current vs. Frequency

0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

ACTIVE SUPPLY CURRENT vs. FREQUENCY

T = 25˚C

Frequency (MHz)

(mA)

= 5.5V

= 5V

= 2.7V

= 3.0V

= 3.3V

= 3.6V

= 4V

= 4.5V

= 6V

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 125 126

Pas de commentaire

Rainbow-electronics ATmega103L Manuel d'utilisateur Page 110