Rainbow-electronics DS1393 Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
DS1390/DS1391/DS1392/DS1393
Low-Voltage SPI/3-Wire RTCs with
Trickle Charger
8 _____________________________________________________________________
CAPACITANCE
(T
A
= +25°C)
PARAMETER
SYMBOL
CONDITIONS
MIN TYP MAX
UNITS
Capacitance on All Input Pins C
IN
10 pF
Capacitance on All Output Pins
(High Impedance)
C
IO
10 pF
WARNING: Under no circumstances are negative undershoots, of any amplitude, allowed when the device
is in write protection.
Note 1: Limits at -40°C are guaranteed by design and not production tested.
Note 2: All voltages are referenced to ground.
Note 3: The use of the 250 trickle-charge resistor is not allowed at V
CC
> 3.63V and should not be enabled. Use of the diode is
not recommended for V
CC
< 3.0V.
Note 4: Measured at V
CC
= typ, V
BACKUP
= 0V, register 0Fh = A5h.
Note 5: Measured at V
CC
= typ, V
BACKUP
= 0V, register 0Fh = A6h.
Note 6: Measured at V
CC
= typ, V
BACKUP
= 0V, register 0Fh = A7h.
Note 7: SCLK, DIN, CS on DS1390/DS1391; SCLK, and CE on DS1392/DS1393.
Note 8: DOUT, SQW/INT (DS1390/DS1393), SQW, and INT (DS1392).
Note 9: The RST pin has an internal 50k(typ) pullup resistor to V
CC
.
Note 10: I
CCA
—SCLK clocking at max frequency = 4MHz for 3V and 3.3V versions; 1MHz for 1.8V version; RST (DS1391/DS1393)
inactive. Outputs are open.
Note 11: Specified with bus inactive.
Note 12: Measured with a 32.768kHz crystal attached to X1 and X2. Typical values measured at +25°C and 3.0V
BACKUP
.
Note 13: With 50pF load.
Note 14: Measured at V
IH
= 0.7 x V
DD
or V
IL
= 0.2 x V
DD
, 10ns rise/fall times.
Note 15: Measured at V
OH
= 0.7 x V
DD
or V
OL
= 0.2 x V
DD
. Measured from the 50% point of SCLK to the V
OH
minimum of SDO.
Note 16: The parameter t
OSF
is the time that the oscillator must be stopped for the OSF flag to be set over the voltage range of
0 V
CC
V
CC(MAX)
and 1.3V V
BAT
5.5V.
Note 17: This delay applies only if the oscillator is enabled and running. If the EOSC bit is 1, the startup time of the oscillator is
added to this delay.
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Commentaires sur ces manuels

Pas de commentaire