Rainbow-electronics DS1803 Manuel d'utilisateur télécharger pdf (Page 5)

DS1803

5 of 11

allows the user to write both potentiometers to the same value with one command and one data value

being issued.

All the write operations begin with a START condition. Following the START condition, the master

device will issue the control byte. The read/write bit of the control byte will be set to ‘0’ for writing the

DS1803. Once the control byte has been issued and the master receives the acknowledgment from the

DS1803, the command byte is transmitted to the DS1803. As mentioned above, there exist three write

operations that can be used with the DS1803. The binary value of each write command is shown in Figure

5 and also in the Table 1.

2-WIRE COMMAND WORDS Table 1

COMMAND COMMAND VALUE

Write Potentiometer-0 101010 01

Write Potentiometer-1 101010 10

Write Both Pots 101011 11

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Rainbow-electronics DS1803 Manuel d'utilisateur Page 5