SECTION 3
1. Board Description
AT91SAM9G20 Microcontroller:
Incorporates the ARM926EJ-S™ ARM® Thumb® Processor
✔ DSP Instruction Extensions, ARM Jazelle® Technology for Java®Acceleration
✔ 32-KByte Data Cache, 32-KByte Instruction Cache, Write Buffer
✔ CPU Frequency 400 Mhz
✔ Memory Management Unit
✔ EmbeddedICE™, Debug Communication Channel Support
Additional Embedded Memories
✔ One 64-KByte Internal ROM, Single-cycle Access At Maximum Matrix Speed
✔ Two 16-KByte Internal SRAM, Single-cycle Access At Maximum Matrix Speed
External Bus Interface (EBI)
✔ Supports SDRAM, Static Memory, ECC-enabled NANDFlash and CompactFlash®
USB 2.0 Full Speed (12 Mbits per second) Device Port
✔ On-chip Transceiver, 2,432-byte Configurable Integrated DPRAM
USB 2.0 Full Speed (12 Mbits per second) Host Single Port in the 208-lead PQFP Package
and Double Port in 217-ball LFBGA Package
✔ Single or Dual On-chip Transceivers
✔ Integrated FIFOs and Dedicated DMA Channels
Ethernet MAC 10/100 Base T
✔ Media Independant Interface or Reduced Media Independant Interface
✔ 128-byte FIFOs and Dedicated DMA Channels for Receive and Transmit
Image Sensor Interface
✔ ITU-R BT. 601/656 External Interface, Programmable Frame Capture Rate
✔ 12-bit Data Interface for Support of High Sensibility Sensors
✔ SAV and EAV Synchronization, Preview Path with Scaler, YCbCr Format
■ Bus Matrix
✔ Six 32-bit-layer Matrix
✔ Boot Mode Select Option, Remap Command
Fully-featured System Controller, including
✔ Reset Controller, Shutdown Controller
✔ Four 32-bit Battery Backup Registers for a Total of 16 Bytes
✔ Clock Generator and Power Management Controller
✔ Advanced Interrupt Controller and Debug Unit
✔ Periodic Interval Timer, Watchdog Timer and Real-time Timer
Reset Controller (RSTC)
Datasheet USG-00019-A01 7/24
Commentaires sur ces manuels