Rainbow-electronics GE863-PY Manuel d'utilisateur télécharger pdf (Page 17)

GE863 Hardware User Guide

1vv0300783 Rev.0 - 10/06/08

4.2.3 Hardware Unconditional Reboot (GE863-QUAD/PY/SIM

only)

To unconditionally Reboot the GE863-QUAD/PY/SIM, the pad RESET# must be tied low for at least

200 milliseconds and then released.

The maximum current that can be drained from the ON# pad is 0,15 mA.

A simple circuit to do it is:

NOTE: don't use any pull up resistor on the RESET* line nor any totem pole digital output. Using pull up

resistor may bring to latch up problems on the GE863-QUAD/PY/SIM power regulator and improper

functioning of the module. The line RESET* must be connected only in open collector configuration.

TIP: The unconditional hardware reboot should be always implemented on the boards and software

should use it as an emergency exit procedure.

RESET#

Unconditional Reboot

impulse

GND

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 79 80

Pas de commentaire

Rainbow-electronics GE863-PY Manuel d'utilisateur Page 17