Rainbow-electronics ATmega128RFA1 Manuel d'utilisateur Page 482

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 524
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 481
482
8266A-MCU Wireless-12/09
ATmega128RFA1
Figure 31-16. State Machine Sequence for Changing the Instruction Word
Test-Logic-Reset
Run-Test/Idle
Shift-DR
Exit1-DR
Pause-DR
Exit2-DR
Update-DR
Select-IR Scan
Capture-IR
Shift-IR
Exit1-IR
Pause-IR
Exit2-IR
Update-IR
Select-DR Scan
Capture-DR
0
1
0
1 1 1
0 0
0 0
1 1
1
0
1
1
0
1
0
0
1
0
1
1
0
1
0
0
00
11
31.9.2 AVR_RESET (0xC)
The AVR specific public JTAG instruction is used for setting the AVR device in the
Reset mode or taking the device out from the Reset mode. The TAP-controller is not
reset by this instruction. The one bit Reset Register is selected as Data Register. Note
that the reset will be active as long as there is a logic “one” in the Reset Chain. The
output from this chain is not latched.
The active states are:
Shift-DR: The Reset Register is shifted by the TCK input.
31.9.3 PROG_ENABLE (0x4)
The AVR specific public JTAG instruction enables programming via the JTAG port. The
16-bit Programming Enable Register is selected as Data Register. The active states are
the following:
Shift-DR: The programming enable signature is shifted into the Data Register.
Vue de la page 481
1 2 ... 477 478 479 480 481 482 483 484 485 486 487 ... 523 524

Commentaires sur ces manuels

Pas de commentaire