Rainbow-electronics ATmega64M1 Manuel d'utilisateur télécharger pdf (Page 147)

147

8209A–AVR–08/09

ATmega16M1/32M1/64M1

18.15 Interrupts

This section describes the specifics of the interrupt handling as performed in

ATmega16M1/32M1/64M1.

18.15.1 Interrupt Vector

PSC provides 2 interrupt vectors:

• PSC_End (End of Cycle): When enabled and when a match with POCR_RB occurs

• PSC_Fault (Fault Event): When enabled and when a PSC input detects a Fault event.

18.15.2 PSC Interrupt Vectors in ATmega16M1/32M1/64M1

18.16 Register Description

Registers are explained for PSC module 0. They are identical for module 1 and module 2.

18.16.1 POC – PSC Output Configuration

• Bit 7:6 – Res: Reserved

These bits are reserved and will always read as zero.

• Bit 5 – POEN2B: PSC Output 2B Enable

When this bit is clear, I/O pin affected to PSCOUT2B acts as a standard port.

0 1 1 CLK I/O / 256

100CLK PLL

1 0 1 CLK PLL / 4

1 1 0 CLK PLL / 32

1 1 1 CLK PLL / 256

Table 18-6. Output Clock versus Selection and Prescaler

PCLKSELn PPREn1 PPREn0 CLKPSCn output

Table 18-7. PSC Interrupt Vectors

Vector

No.

Program

Address Source Interrupt Definition

-- --

5 0x0004 PSC_Fault PSC Fault event

6 0x0005 PSC_End PSC End of Cycle

-- --

Bit 76543210

- - POEN2B POEN2A POEN1B POEN1A POEN0B POEN0A POC

Read/Write R/W R/W R/W R/W R/W R/W R/W R/W

Initial Value 0 0 0 0 0 0 0 0

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 342 343

Pas de commentaire

Rainbow-electronics ATmega64M1 Manuel d'utilisateur Page 147