Rainbow-electronics Atmega169L Manuel d'utilisateur télécharger pdf (Page 233)

233

ATmega169V/L

2514A–AVR–08/02

Reset Register The Reset Register is a test data register used to reset the part. Since the AVR tri-states

Port Pins when reset, the Reset Register can also replace the function of the unimple-

mented optional JTAG instruction HIGHZ.

A high value in the Reset Register corresponds to pulling the external Reset low. The

part is reset as long as there is a high value present in the Reset Register. Depending

on the fuse settings for the clock options, the part will remain reset for a reset time-out

period (refer to “Clock Sources” on page 24) after releasing the Reset Register. The out-

put from this data register is not latched, so the reset will take place immediately, as

shown in Figure 107.

Figure 107. Reset Register

Boundary-scan Chain The Boundary-scan Chain has the capability of driving and observing the logic levels on

the digital I/O pins, as well as the boundary between digital and analog logic for analog

circuitry having off-chip connections.

See “Boundary-scan Chain” on page 235 for a complete description.

Boundary-scan Specific

JTAG Instructions

The instruction register is 4-bit wide, supporting up to 16 instructions. Listed below are

the JTAG instructions useful for Boundary-scan operation. Note that the optional HIGHZ

instruction is not implemented, but all outputs with tri-state capability can be set in high-

impedant state by using the AVR_RESET instruction, since the initial state for all port

pins is tri-state.

As a definition in this data sheet, the LSB is shifted in and out first for all Shift Registers.

The OPCODE for each instruction is shown behind the instruction name in hex format.

The text describes which data register is selected as path between TDI and TDO for

each instruction.

From

TDI

ClockDR · AVR_RESET

TDO

From Other Internal and

External Reset Sources

Internal reset

1 2 ... 228 229 230 231 232 233 234 235 236 237 238 ... 316 317

Pas de commentaire

Rainbow-electronics Atmega169L Manuel d'utilisateur Page 233